Gradnja

Uporaba stikala VEX GO

Uporaba stikala vam omogoča, da sistem VEX GO oživite brez programiranja.

Uporaba stikala z motorjem

Switch piece shown from both sides to illustrate that it has a Port on each side. The Smart Port isn't colored and is smaller, while the Battery Port is orange and larger.

Uporaba motorja s stikalom vam omogoča nadzor motorja brez programiranja.

Stikalo ima dva priključka. Smart Port za priključitev motorja ali LED odbijača ter oranžni priključek za baterijo.

Motor with its cable plugged into the Switch's Smart Port.

Priključite motorni kabel v Smart Port na stikalu, da povežete motor s stikalom.

Diagram of two Switch pieces with Motor Cables plugged into their Smart Ports. On the left the Motor Cable is plugged in fully and there is a green check mark, while on the right the Motor Cable is only plugged in partially and there is a red X.

Preverite, da je motorni kabel popolnoma vstavljen v Smart Port na stikalu. Zvok ‘klik’ bo potrdil, da je kabel popolnoma nameščen v Smart Port.

Diagram of a Switch piece with a Motor Cable and a Battery Cable plugged into their respective ports. The used ports are highlighted in red circles.

Za nadzor motorja s stikalom preverite, da sta motor in baterija priključena na stikalo.

Stikalo ima tri nastavitve

Switch piece with the lever turned to the forward setting marked with a plus sign.

‘+’ : vrti motor v smeri naprej.

Switch piece with the lever turned to a neutral position and pointing straight up.

Nevtralno: izklopi motor.

Switch piece with the lever turned to the reverse setting marked with a minus sign.

‘-’ : vrti motor v obratni smeri.

Oglejte si vse tri nastavitve stikala v tej animaciji.

Uporaba stikala z LED odbijačem

LED Bumper with its cable plugged into the Switch's Smart Port.

Priključite kabel LED odbijača v Smart Port na stikalu, da povežete LED odbijač s stikalom.

Diagram of two Switch pieces with LED Bumper Cables plugged into their Smart Ports. On the left the LED Bumper Cable is plugged in fully and there is a green check mark, while on the right the LED Bumper Cable is only plugged in partially and there is a red X.